Configuration and component identification

DF-GEN-01-TP-01 / DRAFT-1 / DF-GEN-01 / DEMO-01

Inert model/approved training fixture only. Not an OEM operating SOP, service release or competence certificate.

1. Confirm the concept boundary

   Read DF-GEN-01 / DEMO-01. Use the inert concept model or a separately approved training fixture only.

   HOUSING · Expected: The configuration and exercise boundary are stated.

2. Locate the access door

   Select the named service door and inspect its hinge relationship.

   DOOR · Expected: Door and housing are distinct components.

3. Count retaining assemblies

   Identify upper and lower retaining assemblies. Confirm exactly two independent housing-side pivots.

   CLIP_UPPER · Expected: Two named retaining assemblies; no duplicated cover hardware.

4. Identify the cover and support

   Locate the round cover and its fictional support carriage in inspection view.

   COVER_SUPPORT · Expected: Cover, support and fixed housing can be distinguished.

5. Inspect training A

   Locate the correct training cartridge and the source view showing it seated.

   ELEMENT_A · Expected: A identity remains consistent across the source and model.

6. Compare profile B

   Compare B’s differing end profile without placing B in the housing.

   ELEMENT_B · Expected: The mismatch is described; B remains outside.

7. State the stop condition

   An unknown configuration or incompatible profile is a HOLD for instructor/source review.

   ELEMENT_B · Expected: Progression stops before a forced fit.

8. Record what is known

   Use the exercise record to note configuration, sources, observed parts and remaining questions.

   HOUSING · Expected: No instrument reading or equipment service status is invented.