DF-GEN-01-TP-01 / DRAFT-1
Configuration and component identification
Inert model/approved training fixture only. Not an OEM operating SOP, service release or competence certificate.

Objective: Recognise the assigned concept configuration and name its components before practising a sequence.

1. Confirm the concept boundary
Read DF-GEN-01 / DEMO-01. Use the inert concept model or a separately approved training fixture only.
Component: HOUSING
Expected: The configuration and exercise boundary are stated.

2. Locate the access door
Select the named service door and inspect its hinge relationship.
Component: DOOR
Expected: Door and housing are distinct components.

3. Count retaining assemblies
Identify upper and lower retaining assemblies. Confirm exactly two independent housing-side pivots.
Component: CLIP_UPPER
Expected: Two named retaining assemblies; no duplicated cover hardware.

4. Identify the cover and support
Locate the round cover and its fictional support carriage in inspection view.
Component: COVER_SUPPORT
Expected: Cover, support and fixed housing can be distinguished.

5. Inspect training A
Locate the correct training cartridge and the source view showing it seated.
Component: ELEMENT_A
Expected: A identity remains consistent across the source and model.

6. Compare profile B
Compare B’s differing end profile without placing B in the housing.
Component: ELEMENT_B
Expected: The mismatch is described; B remains outside.

7. State the stop condition
An unknown configuration or incompatible profile is a HOLD for instructor/source review.
Component: ELEMENT_B
Expected: Progression stops before a forced fit.

8. Record what is known
Use the exercise record to note configuration, sources, observed parts and remaining questions.
Component: HOUSING
Expected: No instrument reading or equipment service status is invented.