DF-GEN-01-TP-02 / DRAFT-1
Supported cover and cartridge-path rehearsal
Inert model/approved training fixture only. Not an OEM operating SOP, service release or competence certificate.

Objective: Inspect the rigid model relationships and supported path; this is not an operating instruction.

1. Begin with identification
Complete the configuration/component exercise and state the inert-model boundary.
Component: HOUSING
Expected: Correct fixture and source revision are identified.

2. Inspect access
Open the model access-door view. Check the door/fixture relationship visually.
Component: DOOR
Expected: Door clears the represented support path.

3. Inspect the upper pivot
Select the upper retaining assembly and observe that its pivot stays on the fixed structure.
Component: CLIP_UPPER
Expected: The upper assembly is conserved.

4. Inspect the lower pivot
Select the separate lower assembly; the cover remains seated until both represented states have been reviewed.
Component: CLIP_LOWER
Expected: Two assemblies remain; housing is fixed.

5. Inspect supported separation
Move to the axial cover-inspection pose. The support carriage follows the cover.
Component: COVER
Expected: Cover motion is axial and continuously supported.

6. Inspect the clear position
View the cover’s supported rightward inspection position.
Component: COVER_SUPPORT
Expected: The cartridge axis is clear before A moves.

7. Inspect the cradle
Observe the lowered extension and subsequent raised support pose.
Component: CRADLE
Expected: Support is in place before A is shown withdrawn.

8. Inspect the same A
Move toward full inspection spread and follow A along the same axis.
Component: ELEMENT_A
Expected: The original A stays rigid; B does not move into the housing.

9. Inspect the reverse path
Return the inspection slider toward assembly: A returns before supports retract and the door closes.
Component: ELEMENT_A
Expected: The inverse order is visible; no new cartridge appears.

10. Close the exercise record
Record unclear geometry or evidence for a qualified reviewer. Physical fit and release need their own approved source.
Component: HOUSING
Expected: Model inspection is not recorded as real equipment readiness.